PRG900CB – GRAPHIC DISPLAY CONTROL UNIT FOR 1 OR 2 24V MOTORS + CHARGER + NiMH BATTERIES

PRG900CB – ELECTRONIC CONTROL UNIT PROGRAMMERS FOR THE MANAGEMENT OF ONE OR TWO MOTORS + charger and NiMH batteries
Electronic PRG900CB control unit programmer for the control of 24Vdc hinged gates with
intelligent time control functions that allow you to control the position of
the hinged and sliding gates, .

The PRG900CB control uniti fitted with a multi-decoding module S449
– S486 – S504 – S508. Gate travel time programming is fully automatic
and guided by a 6-digit display which allows you to visualise the number
of manoeuvres carried out and to set several parameters such as the
type of motor, the torque setting and the limited opening distance.

Dip-switches allow you to set the system parameters including: the
sequential button mode, automatic reclosing, warning lamp pre-flashing,
intermittent warning lamp activation, indicator light and photoelectric cell
function setting and electric lock enable.

PRG900CB – GRAPHIC DISPLAY CONTROL UNIT FOR 1 OR 2 24V MOTORS + CHARGER + NiMH BATTERIES

PRG900CB – ELECTRONIC CONTROL UNIT PROGRAMMERS FOR THE MANAGEMENT OF ONE OR TWO MOTORS + charger and NiMH batteries
Electronic PRG900CB control unit programmer for the control of 24Vdc hinged gates with
intelligent time control functions that allow you to control the position of
the hinged and sliding gates, .

The PRG900CB control uniti fitted with a multi-decoding module S449
– S486 – S504 – S508. Gate travel time programming is fully automatic
and guided by a 6-digit display which allows you to visualise the number
of manoeuvres carried out and to set several parameters such as the
type of motor, the torque setting and the limited opening distance.

Dip-switches allow you to set the system parameters including: the
sequential button mode, automatic reclosing, warning lamp pre-flashing,
intermittent warning lamp activation, indicator light and photoelectric cell
function setting and electric lock enable.

If you are an electrician or automation specialist, call +39.0558778855
or write an email to: commerciale@automazione-cancelli.net
to get a quote/offer and an extra discount

PRG304E – ELECTRONIC MICROPROCESSOR CONTROL UNIT FOR 230V MOTORS

PRG304E  – ELECTRONIC CONTROL UNIT PROGRAMMERS FOR TWO 230V MOTORS
WITH MAXIMUM POWER YIELD 650W.
ELECTRONIC CONTROL UNIT, BASIC VERSION
Digital work time control. Command inputs: TA, TC and TB. Security inputs:
photocells, safety edge (N.C. contact or 8.2 kΩ), digital safety edge.
Output for a courtesy light 230Vac 300W and for a led warning light. The
appliance is supplied with a S449, 433MHz, FM decoder.
Suitable for the control of automatic rolling shutters.

If you are an electrician or automation specialist, call +39.0558778855
or write an email to: commerciale@automazione-cancelli.net
to get a quote/offer and an extra discount

PRG807001 – ELECTRONIC MICROPROCESSOR CONTROL UNIT FOR 230V MOTORS

PRG807001  – ELECTRONIC CONTROL UNIT PROGRAMMERS FOR TWO 230V MOTORS
WITH MAXIMUM POWER YIELD 450W.
Digital work time control separately memorised for each gate leaf guided by a
6-digit display. Possible operation without mechanical travel limits. Torque setting.
Maximum power initial thrust control, torque limitation and deceleration
management with deceleration zone control. The appliance is fitted with an
interface for the insertion of a standard Cardin radio receiver card.
Suitable for the control of automatic gates and doors with two 230V motors.

If you are an electrician or automation specialist, call +39.0558778855
or write an email to: commerciale@automazione-cancelli.net
to get a quote/offer and an extra discount